Table of Contents
Advertisement
4.
5.
6.
7.
8.
50
Hardware Maintenance Manual: xSeries 200
assembly" on page 42 and "System board internal cable connectors" on page 36
for the location of the fan cable connector.
Use a screwdriver to gently pry the filler panel and EMC shield away from the
server.
Note: If you are installing a drive that is a laser product, observe the following
safety precaution:
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or
transmitters) are installed, note the following:
•
Do not remove the covers. Removing the covers of the laser product could
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
•
Use of controls or adjustments or performance of procedures other than
those specified herein might result in hazardous radiation exposure.
DANGER: Some laser products contain an embedded Class 3A or Class 3B laser
diode. Note the following. Laser radiation when open. Do not stare
into the beam, do not view directly with optical instruments, and
avoid direct exposure to the beam.
Touch the static-protective bag containing the drive to any unpainted metal
surface on the server; then, remove the drive from the bag and place it on a static-
protective surface.
Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
Install the drive.
•
If you are installing a 5.25-in drive in bay 2, push the drive into the bay; then,
use the two screws to attach the drive to the drive cage.
•
If you are installing a 3.5-in drive in bay 2, you must attach the 5.25-in
conversion kit, supplied with your option, to the 3.5-in drive.
Note: You can only install a 3.5-in device in bay 4.
Cable the drive.
•
If the drive is an IDE device, plug one connector of the IDE signal cable into
the back of the drive and the other end of the cable into the IDE connector
(IDE1) on the system board. For the location of the IDE connectors, see
"System board internal cable connectors" on page 36.
•
If the drive is a SCSI device, plug one connector of the SCSI signal cable into
the back of the drive and the other end of the cable into the SCSI adapter. See
"Installing an adapter" on page 45.
Advertisement
Table of Contents
