Table of Contents
Advertisement
Installing an adapter
Expansion
slot cover
Adapter
retaining
bracket
Complete the following steps to install an adapter:
Attention: When you handle ESD-sensitive devices, take precautions to avoid
damage from static electricity. For details on handling these devices, see "Handling
static-sensitive devices" on page 39.
1.
Review the information in "Before you begin" on page 38.
2.
Turn off the server and peripheral devices and disconnect all external cables and
power cords; then, remove the side cover. See "Removing the side cover" on page
40 for details.
3.
Determine which PCI expansion slot you will use for the adapter.
Note: Check the instructions that come with the adapter for any requirements,
restrictions, or cabling instructions. It might be easier for you to route any
cables before you install the adapter.
4.
If you are installing a full-length adapter, rotate the front adapter support bracket
to the open (unlocked) position.
5.
Rotate the rear adapter retaining bracket to the open (unlocked) position; then
place it over the rear of the server.
6.
Remove the PCI expansion-slot cover. From the rear of the server, press in on the
slot cover. Grasp it and pull it out of the slot. Store it in a safe place for future use.
Attention: PCI expansion-slot covers must be installed on all vacant slots. This
maintains the electromagnetic emissions characteristics of the server and ensures
proper cooling of server components.
7.
Remove the adapter from the static-protective package. Avoid touching the
components and gold-edge connectors on the adapter.
Adapter
Adapter
support
bracket
45
Installing options
Advertisement
Table of Contents
