Oce TDS800 User Manual page 191

Use the roll loader to load a roll
Fully open the roll compartment.
1
In the drawer, the roll loaders are installed. The roll loaders consist of a metal
frame with a lever and a green knob in the middle of the lever.
Pull the horizontal lever to the right to put the roll loader in vertical position.
2
Pull the lever completely forward. The roll holder is lifted (see Figure 96).
3
[96] Roll loader in vertical position
Remove the roll holder from the paper roll compartment using both hands.
4
Press the green knob inside the roll holder to release the locking mechanism
5
and remove the core from the holder.
You can place the new roll in the groove on top of the manual feed of
Note:
the printer. See the arrow on picture 91 on page 188.
Slide the roll holder in the new roll of material while you press the green knob.
6
Align the roll with the correct size indicator on the roll holder and release the
7
locking mechanism.
Use both hands to place the holder in the roll loader (see Figure 94).
8
Put the holder back in the roll compartment by returning the roll loader lever
9
to its vertical position.
Press the correct button inside the paper roll compartment and feed the paper
10
between the input guide plates as indicated by the arrow (see Figure 95). The
material is fed into the machine.
Also see the stickers inside the roll compartments on how to feed
Note:
paper.
Be careful when you lift the lever to avoid damage to the roll
Attention:
compartment.
Use both hands to slide the material under the metal paper guide until it makes
11
contact, follow the procedure 'Load paper' on page 188.
Media and supplies
2
1
191