Life Gear 97780 Owner's Manual page 11

70
39
5
53
6
37
53 38
72
71
6
Tool:
72
81
5mm Allen Wrench with
Phillips Screwdriver
Step 3
Connect the Hand Pulse Sensor and Speed Buttons Wires (39) from the right Handrail
Tube (6) to the Control Button Wire (53) and Hand Pulse Sensor Extension Wire I (70)
from the Computer Bracket (5). Then install the right Handrail Tube (6) to the Computer
Bracket (5) by inserting the right Handrail Tube (6) onto the Computer Bracket (5), using
two M8x12 Hex. Socket Round Head Bolts (72). Tighten bolts with the 5mm Allen Wrench
with Phillips Screwdriver Provided.
NOTE: The Handrail Tubes are marked "R" for right side of the Handrail Tube and
"L" for left side of the Handrail Tube.
Connect the Hand Pulse Sensor and Incline Buttons Wires (38) from the left Handrail Tube
(6) to the Control Button Wire (53) and Hand Pulse Sensor Extension Wire II (71) from the
Computer Bracket (5). Then install the left Handrail Tube (6) to the Computer Bracket (5)
by inserting the left Handrail Tube (6) onto the Computer Bracket (5), using two M8x12
Hex. Socket Round Head Bolts (72). Tighten bolts with the 5mm Allen Wrench with
Phillips Screwdriver Provided.
Place the Safety Tether Key (37) onto the Computer (34).
Connect power plug of the Power Cord (81) to the treadmill.
NOTE: PLEASE FULLY TIGHTEN ALL HARDWARE INSTALLED IN STEP 1 TO STEP
3 WITH THE TOOLS PROVIDED.
IMPORTANT: While sliding the handrail tubes oto the computer bracket, make sure the
wires are installed inside the handrail tubes and pay attention not to pinch the wires.
Hardware:
(72) Hex. Socket Round
Head Bolt M8x12
4 PCS
10