Welding Parameters And Functions; Welding Parameters (In Edit Channel Menu 2/6) - Kemppi 350 Operating Manual

2. Welding channel (job) selection. There are 10 memory channels available per USER channel.
There are 10 USER channels . If the channel is empty you can create a new (job) channel
by pressing the key below the LCD screen text stating NEW.
3. MENU button for entering the main menu list. Proceed following the LCD screen menu
guidance.
P65 main menu list
Edit Channel
User Identification
Weld Data
System Config Menu
Language
Select Feeder (WF#)
MMA on/off
Buttons in different situation (shortcut) include functions depending on menu/task.
4. Potentiometer for making adjustments to selected values
5. Up/down arrow keys for moving vertically in the menu structure
6. Pre-programmed menu shortcut keys
• F1 for displaying channel information
• F2 for selecting the USER
• F3 for selecting another parallel connected wire feeder sub system as a setup target.
7. LCD menu display
8. Soft key buttons. Function according to the menu location/task.
EN
4.3

welding ParaMeters and FunCtiOns

4.3.1 welding parameters
Mig
WFSpeed
WFS-Max
WFS-Min
Voltage
VoltageMax
VoltageMin
Dynamics
10
for making changes to existing welding channel
for selecting one user out of ten
for checking out the values of the last weld
for device configuration and information
for selecting your menu language
for selecting another parallel wire feeder as a setup target
for activating electrode welding (licence needed)
(In Edit Channel menu 2/6)
0.7 – 25 m/min
8 – 50V 0.1V steps
-9 ... +9 Factory setting is 0
0.05 m/min steps when WFSpeed < 5 m/min and
0.1 m/min steps when WFSpeed > 5 m/min
Set the limit for maximum WFSpeed
Set the limit for minimum WFSpeed
Controls the length of the arc
Set the limit for maximum voltage value
Set the limit for minimum voltage value
Controls the short circuit behaviour of the arc. The lower
the value the softer the arc is. The higher the value the
rougher the arc is.