Table of Contents
Advertisement
Chapter 4 Firmware Upgrade for GV-IPCAM H.264
GeoVision will periodically release the updated firmware of GV-IPCAM H.264 on the website.
The new firmware can be simply loaded into the GV-IPCAM H.264 by using the Web interface
of GV-IPCAM H.264 or IP Device Utility of the GV-NVR System Lite.
Important Notes before You Start
Before you start updating the firmware, please read these important notes:
1.
While the firmware is being updated,
A) the power supply of the camera must not be interrupted, and
B) do not unplug the Ethernet cable of the camera if the cable is the source of power
supply (Power over Ethernet or PoE supported).
2.
Do not turn the camera power off in 10 minutes after the firmware is updated.
3.
If you use the IP Device Utility for firmware upgrade, the GV-NVR System Lite used to
upgrade firmware must be under the same network of the camera.
WARNING: The interruption of power supply during updating causes not only update
failures but also damages to the camera. In this case, please contact your sales
representative and send your device back to GeoVision for repair.
28
Advertisement
Table of Contents
Need help?
Do you have a question about the GV-NVR System Lite and is the answer not in the manual?