Charging The Nxt-Bp Using The Nxa-Base/1 - AMX Modero CV7 Operation/Reference Manual

Alignment
pegs
FIG. 29
NXA-BASE/1 shown aligning with NXT-CV7 panel
The battery base CANNOT be hot-swapped. An NXT can not be receiving power
(through a connected power supply) and then be connected to a battery base.
Always POWER OFF the panel before installing the NXA-BASE/1.
8.
Slide the rear battery locking slider in the opposite direction. This turns the latching mechanism and
secures the panel to the base.
9.
Upon successful connection, the AMX logo appears on the panel to indicate that the panel is properly
connected and receiving power.

Charging the NXT-BP using the NXA-BASE/1

1.
Insert the single battery into the battery compartment shown in FIG. 28 on page 26.
2.
Follow the procedures from the previous sub-section to attach the NXT-CV7 to the NXA-BASE/1.
3.
Insert a 2-pin connector from a power supply to the rear PWR connector on the NXT-CV7 Modero panel.
Refer to the Battery Base Page section on page 96 to view the charging progress of the connected NXT-
BP.
7" Modero Touch Panels
CV7 Touch Panel Accessories
Battery
locking
mechanism
(with locking
slider)
27