Table of Contents
Advertisement
6. Test the incoming wiring by connecting the panel connections to their terminal locations and
applying power. Verify that the panel is receiving power and functioning properly before finalizing
the installation.
Install the four #4-40 Mounting Screws
(included) into these four holes
Mounting Tab
FIG. 41
Wall Mount panel installation configuration for flat surfaces
7. Disconnect the terminal end of the power cable from the power supply.
Don't disconnect the connectors from the touch panel. The unit must be installed with
the necessary connectors before being inserted into the solid surface.
8. Carefully slide the main unit into the cutout until the Mounting Tabs of the CV7 unit lie flush
against the wall.
9. Insert and secure four #4-40 Mounting Screws (included) into their corresponding holes located
along the sides of the NXD-CV7 (using a grounded Phillips-head screwdriver) until the unit is
secure and flush against the wall (FIG. 41).
10. Place the Faceplate/Trim Ring assembly (A in FIG. 41) back onto the main unit (B in FIG. 41).
Make sure to align the Microphone, Light, and PIR Motion sensor locations to their respective
openings on the front bezel/faceplate.
7" Modero Touch Panels
Verify that the terminal end of the power cable is not connected to a power source before
plugging in the 2-pin power connector.
The USB connectors can be from a either a USB extension cable, or a wireless USB RF
transmitter.
Flat installation surface
A - Faceplate/Trim Ring
Installation
Attachment is done
along the edges
of the cutout
B - Main CV7 unit
41
Advertisement
Table of Contents
