Table of Contents
Advertisement
Installation
Trim
Ring
Latches
Default Button Trim Ring
(with button openings)
(outside surface shown)
FIG. 32
Removing the default Button Trim Ring
5. From along the internal surface of the Faceplate, remove the six buttons by gently bending each
Button latch up and pulling the button outwards.
6. Remove the pair of clear light pipe strips by bending the two black light pipe latches inwards and
pulling out the strip.
7. Grasp the No-Button Trim Ring on both sides and fit it into the groove along the outside surface of
the Faceplate (made available by the removal of the previous Trim Ring).
8. Gently insert the Trim Ring latches into their corresponding openings on the outer surface of the
internal Faceplate (FIG. 33).
No-Button Trim Ring
Hollow button openings
FIG. 33
Inserting the No-Button Trim Ring
9. Firmly press down around the No-Button Trim Ring until all of the latches are securely inserted into
their openings on the Faceplate, and the No-Button Trim Ring is securely fastened. Verify the
No-Button Trim Ring is firmly inserted onto the Faceplate and that there are no gaps between this
Trim Ring and the outer surface of the Faceplate.
32
Faceplate
CV7 Panel/enclosure
Light Pipe latch
(black)
Button and Light Pipe removal
(showing the internal surface of Faceplate)
Faceplate (outer surface shown)
7" Modero Touch Panels
Button latch
B
Advertisement
Table of Contents
