Alcatel MDR-8000 User Manual page 95

RING TERMINAL MASTER – NOT USED
SYSTEM ID:
ELMC:
RADIO TYPE:
MDR-8000 OC3
RADIO CONFIG: HS Tx
ATPC Enabled
SYSTEM ALARM Visual/Audible
RCV SWITCHING:
Disable AGC
OPTIONS:
Option Key:
SELECT RING TERMINAL NORMAL AT FIRST RADIO IN AN INCOMPLETE RING, WHEN
BUILDING OUT A NEW RING. THIS PREVENTS HAVING TO GO BACK AND REPROVISION EACH
RADIO WHEN THE RING IS COMPLETE. AS EACH NEW HOP IS ADDED, PROVISION THE
RADIOS ON EACH END AS RING TERMINAL NORMAL AND PROVISION ALL RADIOS IN
BETWEEN AS RING REPEATER NORMAL. IN THE RING TERMINAL NORMAL CONFIGURATION,
THE REPEATER CABLE IS NOT INSTALLED. SYNC ALARMS ARE INHIBITED. THE RF SERVICE
CHANNEL IS ENABLED, ALLOWING SERVICE CHANNEL DATA TO PASS THROUGH THE RF
PORT. WHEN THE RING IS COMPLETE, PROVISION ONE RADIO RING REPEATER MASTER AND
ALL OTHER RADIOS AS RING REPEATER NORMAL.
SELECT RING TERMINAL NORMAL AT RADIOS AT ENDS OF STUBS OFF SUBTENDING RINGS.
SELECT RING TERMINAL PRIMARY WHEN THE RADIO IS THE PRIMARY CONNECTION POINT
TO THE MAIN RING. IN THIS CONFIGURATION, THE REPEATER CABLE IS NOT INSTALLED.
SYNC ALARMS ARE INHIBITED. THE RF SERVICE CHANNEL IS ENABLED, ALLOWING SERVICE
CHANNEL DATA TO PASS THROUGH THE RF PORT. THE RF SERVICE CHANNEL IS DISABLED
WHEN A FAILURE OCCURS.
SELECT RING TERMINAL SECONDARY WHEN THE RADIO IS THE SECOND CONNECTION
POINT TO THE MAIN RING. IN THIS CONFIGURATION, THE REPEATER CABLE IS NOT
INSTALLED. SYNC ALARMS ARE INHIBITED. THE RF SERVICE CHANNEL IS DISABLED. THE
RF SERVICE CHANNEL IS ENABLED WHEN A FAILURE OCCURS ALLOWING SERVICE
CHANNEL DATA TO PASS THROUGH THE RF PORT.
Figure 4-2 DS1/E1, DS3, OC3/STM-1 Radio Configuration Provisioning (Sheet 4 of 4)
RADIO LINK ID: Disable
TEST1
OC-3 128 QAM
HS Rx
A&B PA Present
RELAYS ON/NO
BER Disable
Stat/Prov/WaySide
Ring Repeater Normal
Terminal Normal
Repeater
Primary
Ring Terminal Secondary
Station Alarm 13-16 RSL Alarm Enable
Ring Repeater Master
Degrade Enable
LMW-9089
09/08/03
4-7