Alcatel MDR-8000 User Manual page 235

DS3 Cable Connections
A.2.5.1
Recommended connectorized cable assembly for all applications except repeaters, PN 632-
4429-096/180 (8/15 ft RG-59B/U coax cable with straight male BNC connector on one end
and right angle male BNC connector on other end). For repeater applications, recommend
PN 632-4288-096/180 (8/15 ft RG-59B/U coax cable with straight male BNC connector on
each end). See Figure A-8 for locations.
Wayside DS1 Cable Connections
A.2.5.2
Recommended connectorized cable assembly – PN 695-4125-041 (26 AWG 5 pair shielded,
jacketed cable with 9-pin D-type connector on one end). See Figure A-8 for shelf connector
location and pinout. Refer to Table A-2 for mating cable wiring and color code.
Table A-2 DS1 LBO Wayside DS1 Connector Mating Cable – Wiring and Pinout
J201 (INPUTS)
FUNCTION
LINE 1 TIP IN
LINE 1 RING IN
LINE 2 TIP IN
LINE 2 RING IN
LINE 3 TIP IN
LINE 3 RING IN
NOT USED
NOT USED
GND
NOT USED
DS3 Repeater Cable Connections
A.2.5.3
The DS3 repeater cable carries clocks, data, and overhead for two
directions. It does not carry DS3 or wayside DS1 traffic. DS3 and way-
side DS1 cables must be run separately. If the 401 cable is not used, the
embedded data in the overhead must also be cabled individually. In
this case, individual cables must be run for MCS-11, audio, RS-232,
and ELMC.
Recommended connectorized cable assembly – PN 695-7836-001/005 (25 pair shielded
cable with 50 pin Amp connectors) (SCSI). See Figure A-8 for shelf connector location and
pinout.
END 1 WIRE COLOR
01 BLACK
06 RED
02 BLACK
07 WHITE
04 BLACK
08 GREEN
05 BLACK
09 BLUE
03 BLACK
10 YELLOW
Note
202 (OUTPUTS)
WIRE COLOR END 2
BLACK 01
RED 06
BLACK 02
WHITE 07
BLACK 04
GREEN 08
BLACK 05
BLUE 09
GND 03
YELLOW 10
FUNCTION
LINE 1 TIP OUT
LINE 1 RING OUT
LINE 2 TIP OUT
LINE 2 RING OUT
LINE 3 TIP OUT
LINE 3 RING OUT
NOT USED
NOT USED
NOT USED
NOT USED
A-15