Alcatel MDR-8000 User Manual page 140

Alcatel User Interface – [System, DS3, and DS1 Provisioning -- MDR-8000 DS3]
File View Setup Options
F3 F4
Prov. Save Alarm Status
ELMC Address: J7914
ELMC Description: DURANGO
Radio Configuration
AUDIO 1: Channel
Level
AUDIO 2: Channel
Level
Channel 1
RS-232
Channel
TMN
MCS RSS
RDS/RAS/RCD
Thursday, March 7, 2000
Figure 4 - 14 DS1/E1, DS3, OC3/STM-1 Radio Audio 2 Provisioning
4-52
F5 F6
Analog Monitor Performance
LOCAL DS3 PROVISIONING
Communicating***
Service Channel
1:, 2: OR 3: – THE 64 kb/s SERVICE CHANNEL TO BE INSERTED INTO RADIO
OVERHEAD IS 1, 2, or 3. IF SERVICE CHANNEL 1 IS ALREADY IN USE, SELECT
SERVICE CHANNEL 2 (2:) OR SERVICE CHANNEL 3 (3:) FOR THE AUDIO CHANNEL.
WHATEVER IS SELECTED FOR SERVICE CHANNEL 1, 2, OR 3, IT MUST BE THE SAME
Off E-Lead -GND
0/0 M-Lead Norm
Off E-Lead -GND
0/0 M-Lead Norm
Channel 2
NORM – MODE OF OPERATION SELECTED IS NORMAL. IN THIS MODE
3 MCS Transport
THE RADIO REQUIRES AN OFF HOOK SIGNAL FROM THE EXTERNAL
AUDIO EQUIPMENT. THIS MEANS THAT THE AUDIO EQUIPMENT USED
TO CONNECT TO THE RADIO MUST HAVE E AND M-LEAD SIGNALING
Address
CAPABILITY (MOST AUDIO EQUIPMENT DOES HAVE THIS CAPABILITY).
J310 Modem IF THE EXTERNAL AUDIO EQUIPMENT DOES NOT HAVE E AND M-
LEAD SIGNALING CAPABILITY, SELECT O/H AND A CONSTANT OFF-
HOOK SIGNAL WILL BE PROVIDED AUTOMATICALLY BY THE RADIO
CONTROLLER SOFTWARE.
1:27:15 PM USI Version R1.03
0/0 – RADIO REQUIRES 0 dBm AUDIO INPUT SIGNAL AT CONNECTOR J317.
THE RECEIVED AUDIO SIGNALS ARE NOT AMPLIFIED. THE RADIO
OUTPUTS 0 dBm ON AUDIO 2 CONNECTOR J317. THIS SELECTION IS
NORMALLY SUFFICIENT IF THE RADIO AND EXTERNAL AUDIO
EQUIPMENT ARE LOCATED IN THE SAME SHELTER, ROOM AND EVEN
BUILDING. LONGER DISTANCES (SUCH AS BETWEEN BUILDINGS) MAY
REQUIRE AMPLIFICATION ON THE OUTPUT SIGNAL. IN THIS CASE,
SELECT -16/+7 WHERE THE RADIO INPUT REQUIRED IS -16 dBm AND THE
RADIO AMPLIFIES RECEIVED AUDIO SIGNALS TO PROVIDE A +7 dBm
OUTPUT AT AUDIO 2 CONNECTOR J317.
F7 F8
Station Alarm User Control
DS3 Facilities
SELECT E-Lead-24Vdc OR E-Lead GND TO
All Call Detect
BE APPLIED TO SERVICE CHANNEL E-LEAD.
2-Wire Auto Squelch
Repeater D/1
RF/Rptr PPP Transport
A12A J308/J309 Input Clocks
J308/J309 Termination
Controller Version R1.03 MDR-8000 3-DS3
F9
Provisioning
WaySide DS1 Facilities
DTMF
Address 00
RF/Rptr
MDR-1036A
09/06/04