Cable Connections - Alcatel MDR-8000 User Manual

RS-232 Cable Connections
A.2.10
Recommended connectorized cable assembly – PN 695-4125-021 through 025 (26 AWG 5 pair
shielded, jacketed cable with 9-pin D-type connector on each end). See Figure A-12 for shelf
connector locations and pinout.
J315 J1
J318 J307
J316 J308
J317 J309
J312 J312 J310
Figure A-12 RS-232 Connect J312 Location and Pinout
MCS-11 Cable Connections
A.2.11
When MCS is selected to be placed on one of the three service channels and then RSS is
enabled and properly addressed, applicable ports on the controller module are enabled.
This allows the user to interface external MCS-11 Monitor and Control System equipment
at any or all four connectors on the backplane (J307, J308, J309, and J310). Two connec-
tors (J308 and J309) are synchronous, parallel, data ports and provide CLK outputs. Con-
nectors J307 and J310 are asynchronous ports.
GND
RS232-2 OUT
RS232-1 IN
RS232-1 OUT
J312
5 1
9 6
RS232-2 IN
FRONT VIEW
J301 J301
LMW-7216
01/21/04
A-21