Mcs-11 Connections - Alcatel MDR-8000 User Manual

Table 3 - 7 RS-232 Mating Cable Wiring and Color Codes
J312/J313 MDR-8000
FUNCTION END 1
NOT USED 01
NOT USED 06
RS-232 OUT/ 02
RS-232-1 OUT*
NOT USED 07
RS-232 IN/ 03
RS-232-1 IN*
NOT USED 08
NOT USED/ 04
RS-232-2 OUT*
NOT USED/ 09
RS-232-2 IN*
GND 05
NOT USED 10
*J312 on CommPak Radio

MCS-11 Connections

3.15.5
When MCS is selected to be placed on one of the three service channels and then RSS is
enabled and properly addressed, applicable ports on the controller module are enabled.
This allows the user to interface external MCS-11 Monitor and Control System equipment
at any or all four connectors on the backplane (J307, J308, J309, and J310). Two connec-
tors (J308 and J309) are synchronous, parallel, data ports and provide CLK outputs. Con-
nectors J307 and J310 are asynchronous ports.
For proper operation, MCS-11 must be provisioned using the following guidelines:
a. MCS-11 must be selected as one of the service channels.
b. MCS must be assigned a valid address
c. The must be set to
MCS RSS
attached CD for address details. At a site, typically only one RSS is turned on. Station
scanners at all other radios at that site are normally jumpered to the RSS enabled radio
to allow access to their detail scanners. If station scanners are properly wired, detail
scanners always respond, regardless of whether RSS is provisioned
3-28
J312/J313
WIRE COLOR PAIR
BLACK 1
RED 1
BLACK 2
WHITE 2
BLACK 3
GREEN 3
BLACK 4
BLUE 4
BLACK 5
YELLOW 5
on one radio per station. Refer to Appendix B on the
ON
J312/J313 MDR-8000
WIRE COLOR END 2
BLACK 01
RED 06
BLACK 03
WHITE 08
BLACK 02
GREEN 07
BLACK 04
BLUE 09
BLACK 05
YELLOW 10
ON
FUNCTION
NOT USED
NOT USED
RS-232 IN/
RS-232-1 IN*
NOT USED
RS-232 OUT/
RS-232-1 OUT*
NOT USED
NOT USED /
RS-232-2 OUT*
NOT USED/
RS-232-2 IN*
GND
NOT USED
or .
OFF