Alcatel MDR-8000 User Manual page 93

Screen shown is for DS1 Radio. DS3 and OC3/STM-1 radio configura-
tion provisioning is similar. Changes to provisioning do not have to be
made in any particular order.
NOTES
1. ATPC T/O IS A CMD PATH FUNCTION PERFORMED AT XMTR.
2. ATPC TRACKS RCVR WITH HIGHEST LEVEL.
3. LOW POWER ATPC IS 10dB DOWN FROM HIGH POWER.
SELECT ATPC OR ATPC T/O ENABLE AUTOMATIC XMT POWER CONTROL (ATPC) FUNCTION. WHEN PROVISIONED
ATPC OR ATPC T/0, ONE RCVR OUT-OF-LOCK CAUSES HIGH POWER ATPC FOR 10 SECONDS EVERY ONE MINUTE.
IF BOTH RCVRS ARE OUT-OF-LOCK, ATPC GOES TO HIGH POWER AND STAYS AT HIGH POWER UNTIL ONE RCVR
(REVERTS TO ONE RCVR OUT-OF-LOCK MODE) OR BOTH RCVRS LOCK. WHEN PROVISIONED ATPC T/O (TIMEOUT),
IF CMD PATH IS LOST, ATPC GOES TO HIGH POWER FOR FIVE MINUTES THEN GOES TO LOW POWER. THEN, EVERY
HOUR, ATPC GOES HIGH FOR 10 SECONDS AND THEN GOES TO LOW POWER. THIS CONTINUES UNTIL THE CMD
PATH IS RESTORED. SELECT DISABLE TO DISABLE ATPC FUNCTION.
SYSTEM ID:
RADIO TYPE:
RADIO CONFIG:
SYSTEM ALARM
RCV SWITCHING:
OPTIONS:
SELECT Relay Card Present IF SHELF IS EQUIPPED WITH
A RELAY INTFC MODULE. SELECT Relay Card Not Present
IF SHELF IS NOT EQUIPPED WITH A RELAY INTFC CARD.
Figure 4-2 DS1/E1, DS3, OC3/STM-1 Radio Configuration Provisioning (Sheet 2 of 4)
Note
ELMC: TEST1 RADIO LINK ID:
MDR-8000 DS1 16 LINES
HS Tx/HS Rx TERMINAL
ATPC Enabled A&B PA Present
Visual/Audible RELAYS ON/NO
Disable AGC BER Disable
Option Key: Stat/Prov/WaySide
SELECT RSL Alarm Enable TO ENABLE ALARM ON USI
ALARM AND STATUS SCREEN WHEN RSL DROPS
BELOW THRESHOLD. SELECT RSL Alarm Disable TO
INHIBIT ALARM.
Disable
128 TCM 6-8 GHz
Relay Card Present
Station Alarm 13-16 RSL Alarm Enable
MDR-1031
09/06/04
4-5