Wayside Ds1 Repeater; Ds3 Repeater (J401 On One Shelf To J401 On Second Shelf) - Alcatel MDR-8000 User Manual

Wayside DS1 Repeater

3.9.2
Recommended connectorized cable assembly – PN 695-4125-051 (26 AWG 5 pair shielded,
jacketed cable with 9-pin D-type connector on each end). See Figure 3 - 9 for Wayside DS1
repeater interconnect.
SHELF 1
OUTPUT J202
J201
INPUT

DS3 REPEATER (J401 ON ONE SHELF TO J401 ON SECOND SHELF)

3.10
The DS3 repeater cable carries clocks, data, and overhead for two
directions. It does not carry DS3 or wayside DS1 traffic. DS3 and way-
side DS1 cables must be run separately. If the 401 cable is not used, the
embedded data in the overhead must be cabled individually. In this
case, individual cables must be run for MCS-11, audio, RS-232, and
ELMC.
Recommended connectorized cable assembly – PN 695-7836-001/005 (25 pair shielded cable
with 50 pin Amp connectors) (SCSI). See Figure 3 - 10 for shelf connector location and
pinout. Refer to Interconnect section on attached CD for mating cable wiring and color code.
Use repeater cables for cabling repeater shelf 1 to repeater shelf 2 (east-
bound/westbound data/clock)
Figure 3 - 9 Wayside DS1 Repeater Interconnect
Note
Note
SHELF 2
J202 OUTPUT
J201
INPUT
LMW-7071-sm
7/24/02
3-15