Your Ceiling Fan - Emerson CAMDEN CF3600AP Owner's Manual

BP7384 Camden, CF3600
How to Wire

Your Ceiling Fan

If you feel that you do not have enough
electrical wiring
experience, have your fan installed by a
licensed electrician.
WARNING
!
Turning off wall switch is not sufficient.
To avoid possible electrical shock, be
sure electricity is turned off at the main
fuse box before wiring. All wiring must be
in accordance with National and Local
codes and the ceiling fan must be
properly grounded as a precaution
against possible electrical shock.
1. Connect the green grounding lead from
the hanger ball
grounding lead from the hanger bracket
to the grounding conductor of supply
(this may be a bare wire or wire with
green colored insulation). Securely
connect wires with wire connectors
supplied. (Figure 14.)
WARNING
!
This product is designed to use only
those parts supplied with this product
and/or any accessories
specifically for use with this product by
Emerson Electric Co. Substitution of
parts or accessories not designated for
use with this product by Emerson Electric
Co. could result in personal injury or
property damage.
2. Securely connect the fan motor white
wire to the supply white (neutral) wire
using wire connector supplied (Figure
14). Securely connect the fan motor
black wire and blue wire to the supply
black (hot) wire using wire connector
supplied (Figure 14). After connections
have been made, turn leads upward
and carefully push leads into the outlet
box, with the white and green leads on
one side of the outlet box and the black
and blue leads on the other side of the
outlet box.
3/12/09 12:37 PM Page 10
GROUND
WIRE
LISTED
WIRE
CONNECTOR (3)
knowledge or
GREEN WIRE
(GROUND) FROM
HANGER BRACKET
Figure 14
Check to see that all connections are
tight, including ground, and that no bare
wire is visible at the wire connectors,
and the green
except for the ground wire. Do not
operate fan until blades are in place.
Noise and fan damage could result.
3. Screw the two 1-1/4" threaded studs
(supplied) into the tapped holes in the
hanger bracket (Figure 13).
4. Lift the ceiling cover up to the threaded
studs and turn until the studs protrude
through the holes in the ceiling cover
(Figure 15).
designated
5. Secure the ceiling cover in place by
sliding lockwashers (supplied) over the
threaded studs and installing the two
knurled knobs (supplied). (Figure 15).
Tighten the knurled knobs securely
until the ceiling cover fits snugly against
the ceiling.
10
BLACK AND BLUE
FAN WIRES
BLACK SUPPLY
GREEN WIRE
(HOT)
(GROUND) FROM
HANGER BALL
NOTE: CEILING COVER
OMITTED FOR CLARITY.
WARNING
!
Model No.: CF3600
WHITE SUPPLY
(NEUTRAL)
WHITE FAN
WIRE