Table of Contents
Advertisement
BP7384 Camden, CF3600
THIS FAN IS SUITABLE FOR DAMP LOCATIONS
SUCH AS COVERED PORCHES, COVERED PATIOS, AND COVERED
DECKS...ANYWHERE THERE IS A ROOF OVERHEAD.
This Manual is Designed to Make it as Easy as Possible for You to
Assemble, Install, Operate and Maintain Your Ceiling Fan
Tools Needed for Assembly
One Phillips head screwdriver
One wire stripper
One stepladder
Materials
Wiring, outlet box and box connectors
must be of type required by the local code.
The minimum wire shall be a 3-conductor
(2-wire with ground) of the following sizes:
For your convenience, check-off boxes are provided next to each step. As each
step is completed, place a check mark in the box. This will insure that all steps
have been completed and will be helpful in finding your place should you be
interrupted.
WARNING
!
Do not install or use fan if any part is
damaged or missing. Call Toll-Free:
1-800-654-3545
WARNING
!
This product is designed to use only
those parts supplied with this product
and/or
any
accessories
specifically for use with this product by
Emerson Electric Co. Substitution of
parts or accessories not designated for
use with this product by Emerson Electric
Co. could result in personal injury or
property damage.
1. Open carton containing fan. Remove
top half of styrofoam unit. Remove
parts, placing all carton contents on a
soft protective surface to prevent
scratching the painted or plated
finishes, and check to see that you
have received the following parts:
NOTE: If you are uncertain of part
description, refer to exploded view
illustration.
3/12/09
12:37 PM
Page 3
Installed Wire Length
Up to 50 ft.
50-100 ft.
Before assembling your ceiling fan, refer
to section on proper method of wiring
your fan (Page 9). If you feel you do not
have
experience, have your fan installed by a
licensed electrician.
Unpacking Instructions
a. Fan motor assembly
b. One motor cover
c. One coupling cover
d. One ceiling cover
e. One switch adapter plate
f. Four blade flanges
g. Four blade medallions
h. One switch cover plate
i. One hanger bracket
j. One hanger ball/downrod assembly
designated
k. One loose parts bag containing:
1. One clevis pin
2. One hairpin clip
3. Two #8-32 x 1-1/4" threaded studs
4. Two #8 external tooth lockwashers
5. Two #8-32 knurled knobs
6. Thirteen #10-32 x 3/4" oval head
7. Five wire connectors
8. One 3/16" hex wrench
9. One chain coupler
10. One chain pendant
11. Nine #8-32 x 5/8" flat head
12. One 5/16-18 x 1/4" setscrew
13. Three #8-32 x 1/4" flat head screws
14. One pendant
3
Wire Size A.W.G.
14
12
WARNING
!
enough
wiring
knowledge
blade screws
flange screw
Model No.: CF3600
or
Advertisement
Table of Contents
