Emerson CAMDEN CF3600AP Owner's Manual page 6

BP7384 Camden, CF3600
Note: Be sure the flange screws on the
blade assembly are facing down for
correct installation into the motor hub.
3. Insert the blade flange into one of the
mounting holes in the motor hub
(Figure 2). Align the flange with the slot
in the motor assembly. Insert one #8-32
x 5/8" flat head screw (supplied) into
one of the flange mounting holes; do
not fully tighten. Install the second
screw in the same manner; tighten both
screws securely.
#8-32 x 5/8" FLAT HEAD SCREW
(2 per flange/blade assembly)
FLANGE
Figure 2
4. Repeat assembly instructions for the
remaining three blade assemblies.
NOTE: Take care not to scratch fan
housing when installing blades.
5. Remove and retain one of the three
pan head screws from the motor flange
(Figure 3); loosen the other two pan
head screws three or four turns.
Position the switch adapter plate on the
motor flange so that the two screws
mate with the two keyhole slots in the
adapter (Figure 4).
Figure 3
3/12/09 12:37 PM Page 6
6. Turn the switch adapter plate clockwise
and tighten both screws (Figure 4).
Reinstall the other pan head screw in
the remaining hole in the adapter.
PAN HEAD SCREW (3)
Figure 4
7. Securely engage the 3-pin connector
BLADE
ASSEMBLY
from the fan motor assembly with the
MOTOR HUB
switch
MOUNTING HOLE
connectors are keyed and must be
mated correctly before they can be
engaged (Figure 5).
8. Slide the pull chain through the chain
busing located on the side of the switch
cover.
9. Position the switch cover assembly
onto the fan motor switch cover adapter
plate. Align the switch cover assembly
switches with the clearance notches in
the motor assembly switch cover
adapter plate. Secure the cover using
three #8-32 x 1/4" flat head screws
(supplied).
NOTE: Do not pinch wires between the
fan motor assembly and switch cover
PAN HEAD
SCREW (3)
assembly.
MOTOR
FLANGE
6
SWITCH
ADAPTER
PLATE
FAN MOTOR
ASSEMBLY
cover connector. The
Model No.: CF3600