Ceiling Fan Assembly - Emerson HF948BS02 Owner's Manual

3.1
NOTE: For HF948 Only. If you are going to use the
8" hanger pipe, first remove the hanger assembly from
the 22" hanger pipe and install it on the 8" hanger pipe
(Figure 1).
Be sure that the lockwasher and hex nut are securely
tightened and the hairpin clip properly installed onto
the clevis pin bolt to secure the hanger assembly to
the hanger pipe.
3.2
Place the upper canopy and lower canopy on the hanger
pipe assembly, facing in the proper direction. (Figure 2).
3.3
Pass the motor wires and retention cable through the
hanger pipe assembly (Figure 3).

3. Ceiling Fan Assembly

5
CLEVIS PIN BOLT
HANGER
PIPE
LOCKWASHER
HEX NUT
HAIRPIN CLIP
Figure 1
HANGER PIPE
ASSEMBLY
Figure 2
CANOPIES NOT SHOWN FOR CLARITY
MOTOR
WIRE (3)
Figure 3
Please contact 1-800-654-3545 for further assistance
HANGER
ASSEMBLY
UPPER
CANOPY
LOWER
CANOPY
RETENTION
CABLE (1)
HANGER PIPE
ASSEMBLY
emersonfans.com
U.L. Model No.: HF948 & HF956