Table of Contents
Advertisement
BP7384 Camden, CF3600
How to Hang
Your Ceiling Fan
WARNING
!
The fan must be hung with at least 7' of
clearance from floor to blades (Figure 11).
CEILING
AT
LEAST
7'
FLOOR
Figure 11
WARNING
!
The outlet box and joist must be securely
mounted and capable of supporting at
least 50 lbs. Use only a U.L. outlet box
listed as "Acceptable for Fan Support".
WARNING
!
To reduce the risk of fire, electric shock,
or personal injury, mount fan to outlet box
marked "Acceptable for Fan Support",
and use screws supplied with outlet box.
Most outlet boxes commonly used for
support
of
light
acceptable for fan support and may need
to be replaced. Consult a qualified
electrician if in doubt.
1. Securely attach the hanger bracket to
the outlet box using the two screws
supplied with the outlet box (Figure 12).
3/12/09
12:37 PM
Page 9
Hanger bracket must seat firmly against
outlet box. If the outlet box is recessed,
remove wall board until bracket contacts
box. If bracket and/or outlet box are not
securely attached, the fan could wobble
or fall.
TWO SCREWS
SUPPLIED
WITH
OUTLET BOX
Figure 12
2. Carefully lift the fan and seat the
hanger ball/downrod assembly on the
hanger bracket that was just attached
to the outlet box (Figure 12). Be sure
the groove in the ball is lined up with
the
(Figure 13).
Failure to seat tab in groove could cause
damage to electrical wires and possible
shock or fire hazard.
NOTE: CEILING COVER, SUPPL Y WIRES AND FAN
WIRES OMITTED FOR CLARITY.
fixtures
are
not
Figure 13
To avoid possible fire or shock, do not
pinch
ball/downrod
bracket.
9
WARNING
!
OUTLET
BOX
HANGER
BRACKET
TAB
tab
on
the
hanger
WARNING
!
OUTLET
BOX
HANGER
BRACKET
HANGER BALL/
DOWNROD ASSEMBLY
1-1/4" THREADED
STUD (2)
WARNING
!
wires
between
the
assembly
and
Model No.: CF3600
bracket
hanger
hanger
Advertisement
Table of Contents
