Attach Bubble - Bosch VG4 Series Installation Manual

AutoDome Modular Camera System
3.10

Attach Bubble

The Dome Bubble/trim assembly attaches to the In-Ceiling Housing.
1. Place the bubble over the Camera Module, and align it until it settles.
2. Rotate the bubble clockwise until it locks in position. See Figure 3.13 on page 48.
NOTICE! The dome bubble comes assembled with a white trim ring. An optional black trim
i
ring is supplied separately. To replace the white trim ring, remove the four (4) Phillips head
screws from the inner ring and remove the white trim ring. Then place the black trim ring over
the inner ring, and replace and tighten the four (4) screws.
Ceiling
Ceiling
Fig. 3.14 In-Ceiling Bubble
Bubble Removal
To service the In-Ceiling AutoDome, use the following procedure to remove the Bubble:
1. Loosen the lockscrew in the trim ring using a P1 or smaller Phillips scredriver until the
bubble can rotate freely.
2. Then rotate the bubble counterclockwise approximately 1/4 turn until it releases from
the In-Ceiling Housing. See the figure below for an illustration.
Fig. 3.15 Bubble Release Screw
Bosch Security Systems, Inc.
Lockscrew
LOCK SCREW
Installation Manual
Installing the In-Ceiling Mount | en
In-ceiling
In-Ceiling
Housing
Housing
Camera Module
Camera Module
Bubble
Bubble
F01U010921 | 1.0 | 2006.10
49