Table of Contents
Advertisement
16
en | Preparing the bubble
4
Preparing the bubble
The inside of the housing may contain packing material to safeguard the camera during
shipping. If so, you must remove the packing material before attaching the in-ceiling housing
to the interface box.
Notice!
To avoid excessive moisture saturation inside the housing, limit the amount of time that the
bubble is disconnected from the housing. Bosch recommends that the bubble be removed
from the housing for no more than five (5) minutes.
Remove the bubble from an in-ceiling housing
1.
2.
Figure 4.1: Remove the bubble
4
See also
–
2019-09 | 0.8 |
Loosen the lockscrew (item 1 in the illustration below) in the trim ring using a P1 or
smaller Phillips screwdriver until the bubble can rotate freely.
Rotate the bubble counterclockwise approximately 1/4 turn until it releases from the in-
ceiling housing. See the figure below for an illustration.
Remove the foam inserts surrounding the camera module.
Installing the Ceiling (IP54 Housing) Gasket, page 23
Installation Manual
AUTODOME IP starlight 7000i
Bosch Security Systems
Hide quick links:
Advertisement
Table of Contents
