Mineral Wool; Optional Blower - Heat & Glo PALOMA-BL Owner's Manual

J. Mineral Wool
Explosion Risk.
• Follow ember placement instructions in
manual.
• Do NOT place embers directly over
burner ports.
• Replace ember material annually.
Improperly placed embers interferes with proper burner
operation.
Apply dime size pieces sparingly along front
Figure 8.20
edge of burner. Do not completely block ports.
Page 36
WARNING
Heat & Glo · Paloma · 7031-220G
K. Optional Blower
The GFK-160A Blower has been designed to circulate room
air through the appliance to enhance heat output.
The GFK-160A blower system operates on 120 VAC, 60
Hz power. This is available through a receptacle in the
factory installed junction box. The junction box is mounted
in the bottom of the appliance behind the access panel. A
variable speed control is provided with the blower system
to provide quiet forced air flow at the desired speeds. A
temperature sensor switch, which automatically turns the
blower ON/OFF, is also provided with this kit.
TOOLS REQUIRED: Powered screwdriver with Phillips
head bit; a flashlight is helpful.
CHECK CONTENTS OF SHIPPING CARTON
BLOWER
CONTROL
KNOB
GROUND
CLIP
CONTROL
NUT
SPEED
CONTROL
Compare CONTENTS OF CARTON with the
Figure 8.21
actual parts received. If any parts are missing or damaged,
contact your dealer before starting installation. Do not install
a damaged blower kit.
INSTALLATION PRECAUTIONS
The GFK-160A Blower kit is tested and safe when installed
in accordance with this installation manual. It is your
responsibility to read all instructions before starting installation
and to follow these instructions carefully during installation
to assure maximum benefit from, and safe operation, of the
blower.
This blower is carefully engineered and must be installed only
as specified. If you modify it or any of its components, you
may cause a fire hazard and will void the WARRANTY. In
addition, such action may void the coverage provided by the
owner's home insurance.
WING
NUT
TEMP.
SENSOR
SWITCH
February 8, 2006