Table of Contents
Advertisement
E. Mineral wool
WARNING! Risk of Explosion! Follow mineral wool
placement instructions in manual. DO NOT place embers
directly over burner ports. Replace mineral wool annually.
Improperly placed mineral wool could interfere with proper
burner operation.
Mineral wool is shipped with this gas appliance. to place
the mineral wool:
• Mineral wool caNNot be placed directly over ports. care
should be taken not to cover the lighting trail of ports (from
back to front).
• Place dime-size pieces of mineral wool just in front of the
port trail, but not on or in between the ports (see Figure
10.6). Place individual pieces of mineral wool in front of and
around the gas log where they can be seen. Space them so
that gas can contact them on all sides. avoid stacking the
embers on top of each other. care should be taken so that
the ports are not covered. Failure to follow this procedure
will likely cause lighting and sooting problems.
• Save the remaining mineral wool materials for use during
appliance servicing. the mineral wool provided should be
enough for 3 to 5 applications.
Figure 10.6
44
Heat & Glo • TIARAP-BK-IPI, TIARAP-BR-IPI, TIARAP-CES-IPI Installation Manual • 2344-980_R4 • 11/14
F. Install Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fireplace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Reinstall the glass frame by reinserting the three Phillips
head screws to the firebox. tighten until snug. do not
overtighten. See Figure 10.1 and 10.2 for reference. Reinstall
front casting.
Advertisement
Table of Contents
