Table of Contents
Advertisement
F. Mineral wool
WARNING! Risk of Explosion! Follow ember placement
instructions in manual. DO NOT completely block burner
ports with ember material. Replace ember material annually.
Improperly placed embers interfere with proper burner
operation.
Ember material is shipped with this gas appliance. To place
the ember material:
• Apply dime size pieces sparingly along front edge of
burner. Do not completely block ports.
• Save the remaining ember materials for use during
appliance servicing. The embers provided should be
enough for 3 to 5 applications.
Figure 10.13 Place Mineral wool
G. Install Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fireplace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Reinstall the glass by reinstalling the three fasteners into the
top of the glass frame assembly using a #2 Phillips bit. Tighten
until snug. Do not overtighten. See Figure 10.1 and 10.2
for reference. Reinstall front casting by setting in place and
tightening the thumb screw.
• Reinstall safety barrier
53
Heat & Glo • TIARII-BK-IPI, TIARII-BR-IPI, TIARII-CES-IPI Installation Manual • 2340-980_R9 • 06/15
H. Install Flue Restrictor
In certain situations, it may be necessary to add a flue
restrictor to the appliance.
As a general guideline, the appliance should not need a flue
restrictor with up to approximately 20 ft. of vertical venting.
A vent run with 20 ft. to 30 ft. of vertical venting, may require
the 3-1/2 in. flue restrictor.
A vent run in excess of 30 ft. of vertical venting, may require
the 3-1/4 in. flue restrictor.
To install a flue restrictor in this appliance, loosen (3) opposing
screws on the inside of the firebox on the open flue. Back
the screws out about 1/4 in. See Figure 10.14.
Figure 10.14
Place proper size flue restrictor inside appliance and "hook"
restrictor on screws. Retighten screws. See Figure 10.15.
Figure 10.15
Loosen Screws
Hook onto
screws
Advertisement
Table of Contents
