Heat & Glo PALOMA-BL Owner's Manual page 37

CAUTION
All wiring should be done by a qualified electrician and
shall be in compliance with local codes and with the
National Electric Code ANSI/NFPA NO. 70-current
(in the United States), or with the current CSA C22.1
Canadian Electric Code (in Canada).
DO NOT CONNECT 110-120 VAC WIRING TO THE GAS
CONTROL VALVE OF THIS APPLIANCE.
Disconnect all electrical power. Remove the front
Figure 8.22
door assembly by lifting off of appliance. Remove the lower
access door. Remove the two screws from attaching switch
bracket to the appliance and retain the screws.
Remove the two screws from the front of the
Figure 8.23
lower heat shield. Loosen the two rear screws. Lower the
front of the heat shield.
February 8, 2006
WARNING
Heat & Glo · Paloma · 7031-220G
BLACK WIRES
Attach enclosed wires to the temperature sensor
Figure 8.24
switch/ bracket assembly. The blue wire attaches to the rear
of the bracket and one of the black wires from the variable
speed control attaches closet to the prepunched screw
hole.
FAN
OUTLET
VARIABLE SPEED
CONTROL &
TEMPERATURE
SENSOR SWITCH
WIRES GO HERE
Feed the blue wire and other black wire from
Figure 8.25
the variable speed control behind the gas valve assembly.
Insert the wires into the slots indicated.
Locate the machine screw underneath the firebox
Figure 8.26
on the right side. Position the temperature sensor switch/
bracket assembly over the machine screw and attach with
the wing nut. Finger tighten.
BLUE WIRE BLUE WIRE
CLIP
Page 37