Installing The Baffle; Positioning The Logs - Heat & Glo PALOMA-BL Owner's Manual

H. Installing the Baffle
The baffle is shipped wrapped, inside the firebox. Install the
baffle with the embedded "T" side up, place it on top of the
brackets on the inside of the firebox, ensuring back edge of
baffle makes contact with the back of the firebox.
Figure 8.16
I. Positioning the Logs
REMOVE THE IGNITOR SHIELD FROM THE PILOT
ASSEMBLY PRIOR TO INSTALLING THE LOGS. (Figure
8.17)
PILOT ASSEMBLY
IGNITOR
SHIELD
Figure 8.17
While still breakable, the logs do not become fragile until
after the appliance is burned and they have cured. After
curing, any handling must be done with care as breakage
can easily occur.
PLEASE NOTE: Logs have been designed to work
specifically with the burner of this appliance. Exact
placement will ensure proper operation of your gas
appliance and reduce sooting.
February 8, 2006
Figure 8.18
the log back towards right corner of firebox.
Figure 8.19
notch in log #1. Lean the log back toward the left corner of
the firebox.
Heat & Glo · Paloma · 7031-220G
Place log #1 into the cradle in the burner. Lean
Pin
Locate log #2 over the pin in log #1 and into
Page 35