Section 8: Appliance Setup; Remove Shipping Materials; Unbolting Appliance From The Pallet - Heat & Glo PALOMA-BL Owner's Manual

8
Appliance Setup
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
firebox.
Do not remove the ignitor shield on the pilot assembly until
set up is complete. (Figure 8.1)
PILOT ASSEMBLY
IGNITOR
SHIELD
Figure 8.1
Gas line and power cord are shipped inside back panel. To
access the gas line and power cord, remove the top plate
from the appliance. Remove and retain the two Allen head
screws that hold the back panel in place. Refer to Figure
8.6, page 32.
Using the black grommet located in the component bag, slide
it into the bottom of the back panel and feed the power cord
through the grommet, as shown in Figure 8.2.
Figure 8.2
February 8, 2006
B. Unbolting Appliance from the Pallet
The appliance is bolted and screwed to the pallet for ship-
ping. Use a 1/2 in. socket to remove the bolt in center of
bottom plate. Use a Phillips screwdriver to remove the two
screws in the front of the bottom plate and the two screws
holding the metal strap across the back of the appliance.
Refer to Figure 8.3 for locations.
Figure 8.3
Heat & Glo · Paloma · 7031-220G
Page 31