Table of Contents
Advertisement
Appendix – Command Line Interface
Start-up and Terminal configuration
To start the Command Line Interface, please connect a PC COM port to the RS-232 connector
and activate a terminal emulation software (e.g. Windows' HyperTerminal).
The terminal emulation software should be started in the following configuration:
1. Data rate: 115200 baud.
2. Data format: 8 data bits, 1 stop bit and no parity.
3. Flow control: none.
4. Click the property icon, select settings, make sure that: The Function, arrow,
and ctrl keys act as: Terminal keys, Emulation: VT100.
Login/Logout Procedures
To get access to the CLI, you will have to get the username and password for login. The default
username and password are "admin" and "admin".
Note: We recommend that you configure a new username and password to prevent
unauthorized users from accessing the device.
Command Hierarchy
After logging in, press ? + <enter> to show the 9 command groups.
System
Console
Port
VLAN
Aggr
QoS
Mirror
IP
SNMP
Ratelimit
Exit
Press ? or help to get help. The help depends on the context (where you are in the program):
- At top level, a list of command groups will be shown.
- At group level, a list of the command syntaxes will be shown.
- If given after a command, the syntax and a description of the command will be shown.
www.signamax.eu
- System commands
- Console commands
- Port commands
- VLAN commands
- Aggregation commands
- QoS commands
- Mirror commands
- IP commands
- SNMP commands
- Rate setup commands
- Logout commands
25
Advertisement
Table of Contents
