Table of Contents
Advertisement
The Switch was designed for easy installation and high performance in an environment where
traffic on the network and the number of users increase continuously.
1.4.1 Hardware Interface
24-Port 10/100Mbps+ 2-Port 10/100/1000Mbps
24×10/100Mbps Auto-negotiation Fast Ethernet RJ45 ports
2 ×1000Mbps Auto-negotiation Ethernet RJ45 ports
All RJ45 ports support auto MDI/MDIX, so there is no need to use cross-over cables or an up-
link port
Full-/half- duplex transfer mode for 10/100Mbps Fast Ethernet transmission
Wire speed reception and transmission
Fully compliant with IEEE 802.3 10BASE-T, IEEE 802.3u 100BASE-TX and IEEE802.3ab
1000BASE-T
1.4.2 Performance Features
8.8 G bps switching fabric capacity
Support 8K MAC address.
512KBytes packet buffer
Wire speed packet forwarding rate per system.
Store and forward switching scheme.
1.5 Panel
1.5.1 Front Panel Components
The front panel of the Switch consists of LED indicators, 24-Port 10/100Mbps+ 2-Port
10/100/1000Mbps Gigabit. The figure below shows the front panels of the Switch.
10/100BASE-TX Twisted-Pair Ports (Port1~24): These ports support network speeds of either
10Mbps or 100Mbps, and can operate in half- and full- duplex transfer modes. These ports
also support automatic MDI/MDI-X crossover detection, giving true "plug and play" capability.
Just need to plug-in the network cable to the hub directly and don't care if the end node is NIC
(Network Interface Card) or switch and hub.
10/100/1000M Gigabit Ports (Port 25,26)
LED Indicator: Comprehensive LED indicators display the status of the switch and the network
(see the LED Indicators chapter below).
6
Figure 1-2
Front Panel view of the Switch
SIGNAMAX LLC • www.signamax.eu
Advertisement
Table of Contents
