Table of Contents
Advertisement
Chapter 2 Hardware Installation / Network Setup
Please follow the below instruction to build the wireless network connection between WNRT-626 and your
computers.
2.1
Hardware Installation
Item Name
Description
Antenna
Attached 3dBi dipole antenna.
Radio ON/OFF
Switch the button to activate or deactivate the wireless functions.
Reset / WPS
Reset the router to factory default settings (clear all settings) or start WPS
function. Press this button and hold for 10 seconds to restore all settings to
factory defaults, and press this button for less than 5 seconds to start WPS
function.
1 - 4
Local Area Network (LAN) ports 1 to 4.
WAN
Wide Area Network (WAN / Internet) port.
Power
Power connector, connects to power adapter.
1. Locate an optimum location for the WNRT-626. The best place for your WNRT-626 is usually at
the center of your wireless network, with line of sight to all of your mobile stations.
2. Adjust the antennas of WNRT-626. Try to adjust them to a position that can best cover your wireless
network. The antenna's position will enhance the receiving sensitivity.
3. Connect xDSL/Cable Modem to WAN port of WNRT-626. Usually, this cable would be provided with
your modem. If no cable was supplied with your modem, please use a RJ-45 Ethernet cable
4. Connect all of your network devices to LAN port of WNRT-626. Connect all your computers,
network devices (network-enabled consumer devices other than computers, like game console, or
switch / hub).Connect one of the LAN ports on WNRT-626 to your LAN switch/hub or a computer with
a RJ-45 cable.
8
Advertisement
Table of Contents
