Port Forwarding - Planet WRNT-626 User Manual

Parameters
Enable Static Routing
Destination LAN IP
Subnet Mask
Default Gateway
Hop Count
Interface
Add
Reset
Current Static Routing Table
Delete Selected
Delete All
Reset
After configuration complete, please click "Apply" button to save the configuration. Then you will see a
screen to prompt you the settings are saving successfully. You may press "Continue" for configure other
settings or "Apply" to restart WNRT-626 with new configuration. Please refer to section 4.2.7 for more
information about this screen.
5.6.2

Port Forwarding

The Port Forwarding allows you to re-direct a particular range of service port numbers (from the
Internet/WAN Ports) to a particular LAN IP address. It helps you to host some servers behind the
firewall.
Description
Check this box to enable Static Routing function, unselect this box if you
don't want to turn off NAT function of this router.
Type the Destination LAN IP address you use to access the Internet. Your
ISP or network administrator provides you with this information.
Type the subnet mask for your network. If you do not type a value here, your
ISP or network administrator provides you with this information.
Type the gateway address of your network. Your ISP or network
administrator provides you with this information.
Input which hop count you want to apply to this configuration.
Select the interface which you would like to use (LAN / WAN).
Click to add a configuration to the Current Static Routing Table at the bottom
of this page.
Click "Reset" will clear your current settings to allow you to enter again.
If you want to remove some Destination LAN IP address from the "Current
Static Routing Table", select the Destination LAN IP addresses you want to
remove in the table and then click "Delete Selected".
If you want remove all Destination LAN IP addresses from the table, just click
this button.
Click "Reset" will clear your current selections.
53