Table of Contents
Advertisement
Security Command User Menu
Many of the features of your system have been put into a User Menu
you can access from any Security Command keypad.
To access the User Menu:
1. Press the COMMAND key until MENU? NO YES displays.
2. Select YES. The keypad displays ENTER CODE: –. Enter your
user code. You can now scroll down through the list of system
features available to your authority level.
The following pages detail each User Menu item and provide
instructions on when and how to use them properly.
User Checkin
User Code Level: Master or Standard
Function: This feature allows you to monitor the arrival of latchkey
children or employees by having a special Checkin Report sent to
your alphanumeric or numeric pager. Your system must be
programmed for the Pager Direct™ option. The Appendix section of
this guide contains Quick Reference cards for your wallet or purse.
Sending a Checkin Report:
1. After disarming the system, access the User Menu.
(Or press the COMMAND then 7 key and enter your user code
to send a Checkin Report. This feature operates on 32-character
keypads only.)
2. At the USER CHECKIN? display, press any SELECT key. The
keypad displays USER CHECKIN: 22 ( 22 = user number).
3. The panel sends the Checkin Report containing your account
number and user number to the pager.
User Menu
Zone Activity Check
User Code Level: Master or Standard
Your security system may be programmed for the Zone Activity
Check feature to monitor a person for non-activity. This could be
used for a person living alone to detect when they have not tripped
a disarmed zone within a programmed period of time. This feature
can be programmed for you at any time.
Function: This option allows you to enable or disable the Zone
Activity Check which monitors your system for no zone activity.
When the programmed time period is exceeded because no activity
is detected, your keypads will sound a steady tone and display
PRESS ANY KEY. Pressing any key on the keypad restarts the no
activity programmed time period and prevents your system from
sending a "User Activity Not Detected" report to the central station.
Note: The Zone Activity Check is disabled when a schedule is
entered to allow for sleeping hours and is automatically enabled
when an area is armed or disarmed.
Selecting Zone Activity Check:
1. At the ACTIVITY CHECK? display, press any SELECT key. The
keypad displays ENABLE? YES NO. The default is YES.
2. When NO is selected, the keypad displays CHECK DISABLED
for four seconds and then sends the Activity Check Disabled
message to the central station.
3. When YES is selected, the keypad displays CHECK ENABLED
for four seconds and then sends the Activity Check Enabled
message to the central station.
13
Advertisement
Table of Contents
