Table of Contents
Advertisement
Security Command User Menu
Many of the features of your system have been put into a User Menu
you can access from any Security Command keypad.
To access the User Menu:
1. Press the COMMAND key until MENU? NO YES displays.
2. Select YES. The keypad displays ENTER CODE: –. Enter your
user code. You can now scroll down through the list of system
features available to your authority level.
The following pages detail each User Menu item and provide
instructions on when and how to use them properly.
User Checkin
User Code Level: Master or Standard
Function: This feature allows you to monitor the arrival of latchkey
children or employees by having a special Checkin Report sent to
your alphanumeric or numeric pager. Your system must be
programmed for the Pager Direct™ option. The Appendix section of
this guide contains Quick Reference cards for your wallet or purse.
Sending a Checkin Report:
1. After disarming the system, access the User Menu.
(Or press the COMMAND then 7 key and enter your user code
to send a Checkin Report. This feature operates on 32-character
keypads only.)
2. At the USER CHECKIN? display, press any SELECT key. The
keypad displays USER CHECKIN: 22 ( 22 = user number).
3. The panel sends the Checkin Report containing your account
number and user number to the pager.
Sensor Reset
User Code Level: Master or Standard
Function: Resets smoke or glassbreak detectors. Also clears Fire
and Supervisory zone alarm and trouble keypad displays. Sensor
Reset also clears low battery displays if your system is using
wireless sensors.
Once smoke or glassbreak detectors have tripped, they must be
reset before they can detect any additional alarm conditions. When
Sensor Reset is selected, power to the detectors is temporarily
removed by the system allowing them to reset.
Make sure all smoke is cleared from around the area of the smoke
detectors before performing a Sensor Reset to prevent the alarm
from occurring again.
Resetting the Sensors
1. Access the User Menu.
2. When SENSOR RESET? is displayed, press any SELECT key.
The keypad displays SENSORS OFF for five seconds followed
by SENSORS ON.
3. The keypad returns to the status display.
Enter your user code to reset sensors
While your system is disarmed, you can just enter your user code
and press COMMAND to reset the sensors. (This feature operates
in All/Perimeter and Home/Away systems only.)
This also activates the door strike if your system has an Easy
Entry™ access control keypad.
User Menu
13
Advertisement
Table of Contents
