Table of Contents
Advertisement
The Security Command Keypad
Your system may have one or more easy-to-use Security Command
keypads (16- or 32-character) that allow you to properly operate the
system. The illustration and descriptions below highlight some of the
keypad features:
32-Character Keypad
AC
LED
POWER
JONES RESIDENCE
F R I
2 : 51 AM
ARMED
ARMED
LED
1
2
A B C
D E F
5
6
MN O
P Q R
9
0
Y Z
16-Character Keypad
1
2
3
4
DEF
GHI
JKL
A B C
8
5
6
7
MNO
PQR
STU
VWX
9
0
COMMAND
YZ
The SELECT keys
There are four keys under the display called the SELECT keys.
These keys are one of the features that make your system so easy
to operate. They allow you to choose what to do by pressing the
SELECT key under choices being shown in the display.
2
Lighted display
SELECT keys
Data Entry keys
3
4
G H I
J K L
7
8
S T U
V W X
COMMAND key
COMMAND
ARROW key
Lighted display
SELECT keys
AC LED
POWER
Data Entry keys
COMMAND key
ARROW key
Data Entry keys
These keys allow you to enter your user code when arming or
disarming and enter other information into the system.
The ARROW key
The ARROW key is used to go back through the keypad displays
while operating your system. You can press the ARROW key to back
up through the list of functions in the User Menu or to make a
correction by erasing the last character you entered.
The COMMAND key
The COMMAND key allows you to advance through the keypad
displays or User Menu or complete a data entry function.
AC LED
This LED remains on steady as long as your system is connected to
its AC power supply. Should there be an interruption, the LED turns
off and the system's backup battery maintains normal operation for
a time allowing you to contact our service department.
ARMED LED
This LED is ON steady anytime burglary protection is armed and OFF
when ALL areas are disarmed.
32-Character Keypad User Options Menu
Press and hold the ARROW and COMMAND keys for about two
seconds. The keypad display shows SET BRIGHTNESS. Use the
left SELECT key to lower the display brightness. Use the right
SELECT key to increase the display brightness. Press COMMAND.
At SET TONE, use the left SELECT key to lower the keypad tone.
Use the right SELECT key to raise the keypad tone. Press COMMAND.
At SET VOLUME LEVEL, use the left SELECT key to lower the
keypad volume. Use the right SELECT key to raise the keypad
volume. Press the ARROW key to exit out of the User Options menu.
Introduction
Advertisement
Table of Contents
