Dedicated Micros SD Advanced Installation And Operation Manual page 73

VMD/Activity Inhibit
Add Still Image
Email Image
Protect alarm Images
Switch Spot Monitor
Goto Preset
Email Reporting
Enable Buzzer
Preset Camera
Preset
Relay
Relay Duration
Alarm Image Snapshot Delay
Dedicated Micros ©2009
Select to inhibit (ignore) the VMD/Activity detection feature. Refer
to 'Activity Setup' for more information.
This will record a still image of the trigger along with the standard
recording. This can then be sent on to an external destination.
If this option is selected, a JPEG will be added to the reporting
email (if Email Reporting is selected).
Alarm images can automatically be protected from
being overwritten.
Select to display the alarm zone Primary camera on the
Spot Monitor.
It is possible to action a camera to automatically be sent to a
preset position when an alarm is triggered.
The unit can send an email when an alarm is detected, refer to
'Network-E-mail' for more information.
Select to activate the unit's internal buzzer upon alarm receipt.
The preset camera is the camera which will be sent to a
designated preset position upon alarm activation.
Enter the preset position number for the selected camera here,
refer to 'Unit Operation-PTZ Program' for more information on
establishing camera preset positions.
Select an onboard or external relay to automatically close on
receipt of an alarm.
Enter (in seconds) how long the relay is to remain closed.
This figure allows a delay to be introduced before an alarm
snapshot is taken. This is used when the alarm relates to a PTZ
camera which has to travel to a preset position.