Top/Wall Mount Installation
The COM1 port has 12V of power on pin 9 specifically to power the PowerScan unit.
Do not connect any peripheral but a decoded serial bar code scanner to the Falcon
4620 VMC's COM1 port, or damage can result for both the vehicle mount computer
and the connected peripheral. PSC recommends using only the PowerScan on this
port.
WARNING
Mount the Keyboard and PowerScan Trays
You can now attach the keyboard to the keyboard tray and the PowerScan RF
Base to the PowerScan RF Tray.
1. Attach the keyboard to the keyboard tray with two (2) Phillips head
2. Attach the PowerScan RF Base to the PowerScan RF tray with four (4)
3. Attach the keyboard tray (and PowerScan tray if you ordered one) to the
Connect the Antenna (optional)
Some Falcon 4620 VMCs are equipped
with a radio card requiring an external
antenna, depending upon which option
you ordered. Some units have a radio
card with an integrated antenna.
To install the external antenna option,
complete the following steps:
1. Line up the antenna's base with the
2. Rotate (screw) the antenna on the
3. Adjust the angle of the antenna for
For more information on Radio cards with either internal or external anten-
nas, refer to "Installing an RF Card" on page
User's Guide
screws provided with the keyboard.
Phillips head provided with the PowerScan RF tray.
computer back plate by securing with the five (5) 1/4x20" and 1/2"
enclosed Phillips head screws.
threaded pin on the outside of the
unit.
pin until it is snug.
best reception.
Threaded Base
Threaded Pin
.
33
13