Connecting To A Power Supply - Christie LX501 Manual

Connecting to a power supply

Put the connector of the power cord into the
1.
AC IN (AC inlet) of the projector.
Firmly plug the power cord's plug into the
2.
outlet. In a couple of seconds after the power
supply connection, the POWER indicator will
light up in steady orange.
Please remember that when the DIRECT POWER ON
function activated (
supply make the projector turn on.
WARNING ►Do not connect the projector to a power supply while no lens
unit is attached to it.
►Please use extra caution when connecting the power cord, as incorrect or
faulty connections may result in fi re and/or electrical shock.
• Do not touch the power cord with a wet hand.
• Only use the power cord that came with the projector. If it is damaged, consult
your dealer to get a new one. Never modify the power cord.
• Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.
• Do not distribute the power supply to multiple devices. Doing so may overload
the outlet and connectors, loosen the connection, or result in fi re, electric shock
or other accidents.
• Connect the ground terminal for the AC inlet of this unit to the ground terminal
of the building using an appropriate power cord (bundled).
• This product is also designed for IT power systems with a phase-
NOTICE
tophase voltage of 220 to 240 V.
LX501/LX601i User Manual-Operating Guide
65), the connection of the power
AC IN
Power
cord
17
Setting up
020-000461-01 Rev. 1 (03-2012)