Adjusting The Projector's Elevator - Christie LX501 Manual

Adjusting the projector's elevator

When the place to put the projector is slightly uneven
to the left or right, use the elevator feet to place the
projector horizontally.
Using the feet can also tilt the projector in order to
project at a suitable angle to the screen, elevating the
front side of the projector within 9 degrees.
This projector has 2 elevator feet and 2 elevator buttons.
An elevator foot is adjustable while pushing the elevator
button on the same side as it.
1.
Holding the projector, push the elevator buttons to
loose the elevator feet.
2. Position the front side of the projector to the desired
height.
3. Release the elevator buttons in order to lock the
elevator feet.
4.
After making sure that the elevator feet are locked,
put the projector down gently.
5. If necessary, the elevator feet can be manually
twisted to make more precise adjustments. Hold the
projector when twisting the feet.
CAUTION ►Do not handle the elevator buttons without holding the
projector, since the projector may drop down.
►Do not tilt the projector other than elevating its front within 9 degrees using
the adjuster feet. A tilt of the projector exceeding the restriction could cause
malfunction or shortening the lifetime of consumables, or the projector itself.
Only for LX601i, it is possible to install the projector for any direction with
specified mounting accessories. Consult with your dealer about such a special
installation.
LX501/LX601i User Manual-Operating Guide
29
Operating
To loose an
elevator foot,
push the elevator
button on the
same side as it.
To finely
adjust, twist
the foot.
020-000461-01 Rev. 1 (03-2012)