Fastening The Cables; Using The Security Bar And Slot - Christie LX501 Manual

Setting up

Fastening the cables

To get together the signal cables and
prevent them from coming off, fasten them to
the projector using a commercially available
plastic cable tie. Use a cable tie of size
2.0x5.0mm or smaller. It is recommended
to curl the end of the tie slightly before you
thread it to the tie holder to enable it to get
through easily.
WARNING ►Do not bind the power cord.
►Use only a plastic tie to get together or fasten the cables. A
CAUTION
metallic tie may cause damage to the cables and tie holder.
►Do not bind the cables too tightly. The cables or the hole might be damaged.

Using the security bar and slot

A commercially available anti-theft chain or
wire can be attached to the security bar on
the projector. Refer to the fi gure to choose
an anti-theft chain or wire.
Also this product has the security slot for
the Kensington lock.
For details, see the manual of the security
tool.
WARNING ►Do not use the security bars and slot to prevent the projector
from falling down, since it is not designed for it.
►Do not place anti-theft chain or wire near the exhaust vents.
CAUTION
It may become too hot.
NOTE • The security bar and slot is not comprehensive theft prevention
measures. It is intended to be used as supplemental theft prevention measure.
• The safety bar (
LX501/LX601i User Manual-Operating Guide
4) can be used for the same purpose as the security bar.
11mm
Anti-theft
chain or wire
security bar
16
Tie holder
Cable tie
Security slot
19mm
15mm
020-000461-01 Rev. 1 (03-2012)