Sfp+ Cable; Qsfp+ Cable; Qsfp+ To Sfp+ Cable - HP 7500 Series Installation Manual

If the fiber has to pass through a metallic board hole, the hole must have a sleek and fully filleted
•
surface (the filleting radius must be not less than 2 mm). When passing through a metallic board
hole or bending along the acute side of mechanical parts, the fiber must wear jackets or cushions.
• Insert and remove a plug with care. Never exert a fierce force to the fiber or plug; otherwise the
plug might be damaged or the fiber might be broken. Never pull, press or extrude the fiber fiercely.
For the allowed maximum tensile load and crush load, see

SFP+ cable

You can use the SFP+ cables to connect the SFP+ ports on the 7500 switches. The SFP+ cables available
for the HP 7500 Switch Series are 10 Gbps SFP+ cables, as shown in
Figure 62 SFP+ cable
(1) Connector

QSFP+ cable

You can use QSFP+ cables to connect the QSFP+ ports.
Figure 63 QSFP+ cable
(1) Connector

QSFP+ to SFP+ cable

A QSFP+ to SFP+ cable provides one QSFP+ connector at one end and four SFP+ connectors at the other
end.
Table
(2) Pull latch
(2) Pull latch
138
89.
Figure 62.