Replacing The Poe Dimm - HP 7500 Series Installation Manual

When you remove a cable, pull the pull latch horizontally. Otherwise, the cable cannot be removed
•
smoothly, or even the module or slot could be damaged.
To replace an SFP+/QSFP+/QSFP+ to SFP+ cable:
1. Wear an ESD wrist strap and make sure it makes good skin contact and is well grounded. For
more information, see
2. Gently press the cable plug in, and then pull the pull latch on the cable outward to pull out the
cable plug.
3. Install a new cable. For the installation procedures, see

Replacing the PoE DIMM

NOTE:
Before replacing a PoE DIMM, remove the cables on the card where the PoE DIMM is installed, and then
remove the card from the switch. For information about removing a card, see
To replace a PoE DIMM:
1. Wear an ESD wrist strap and make sure it makes good skin contact and is well grounded. For
more information, see
2. Place the card steadily. Find the PoE DIMM slot (there is a Master mark on the PCB under the slot)
on the PCB.
3. Pull the white clips on the two sides of the PoE DIMM slot outward, as shown in callout 1 on
53.
4. Pull the PoE DIMM out along the guide rails, as shown in callout 2 on
5. Put the removed PoE DIMM on its original shipping materials.
6. Install a new PoE DIMM. For the installation procedures, see
Figure 53 Installing a PoE DIMM
(1) Pull the white clips on the two sides of the DIMM outward
(2) Pull the PoE DIMM out along the guide rails
"Installing FRUs."
"Installing FRUs."
86
"Installing FRUs."
"Replacing a
Figure 53.
"Installing FRUs."
card."
Figure