Verifying The Irf Fabric Configuration - HP 7500 Series Installation Manual

For more information about installing transceiver modules, see "Installing FRUs." For more information
about connecting fibers, see "Connecting your switch to the network."
Figure 37 Connecting two IRF member switches

Verifying the IRF fabric configuration

After you finish configuring basic IRF settings and connecting IRF ports, verify the basic functionality of
the IRF fabric, as follows:
1. Log in to the IRF fabric through the console port of any member switch.
2. Create a Layer 3 interface, assign it an IP address, and make sure the IRF fabric and the remote
network management station can reach each other.
3. Use Telnet or SNMP to access the IRF fabric from the network management station. (See HP 7500
Switch Series Fundamentals Configuration Guide.)
4. Verify that you can manage all member switches as if they were one node.
5. Display the running status of the IRF fabric by using the commands in
Table 11 Displaying and maintaining IRF configuration and running status
Task
Display information about the IRF fabric
Display topology information about the IRF fabric
NOTE:
To avoid IP address collision and network problems, configure at least one MAD mechanism to detect the
presence of multiple identical IRF fabrics and handle collisions. For more information about MAD, see
7500 Switch Series IRF Configuration Guide.
Command
display irf
display irf topology
44
Table 11.
HP