Verifying Operation; Inserting A Cable Into An Sfp - HP StorageWorks 2/32 - SAN Switch Installation Manual

Figure 15: Inserting a cable into an SFP
Note:
cable does not slide in easily, check the orientation.

Verifying Operation

After making the appropriate connections, as outlined in this chapter, use these
steps to verify that the switch is running properly.
1. Access your browser.
2. At the URL address window, type
3. If connected properly, the name of your switch appears (in green) at the
Note:
complete configuration is available if required for a replacement switch. For instructions
on how to back up the configuration, refer to Chapter 4, "Backing Up Configuration
Data and Upgrading Firmware." Or, for more detailed information and commands,
refer to the
SAN Switch 2/32 Installation Guide
The cable is keyed so that it can only be inserted correctly into the SFP. If the
prompt, indicating Healthy/OK.
Backing up the configuration is strongly recommended. This ensures that a
HP StorageWorks Fabric OS Procedures Version 3.0.x/4.0.x User Guide.
Installing the SAN Switch 2/32
SHR-2574A
http://your switch IP address.
57