HP 7500 Series Installation Manual page 20

To install a cable management bracket:
1. Unpack the cable management brackets.
2. Attach the cable management bracket to the chassis, and align the screws with the screw holes in
the chassis, as shown in
3. Fasten the screws.
Figure 10 Attaching cable management brackets on an HP 7506-V
(1) Attach the cable management bracket to the chassis
(2) Screw holes for installing the cable management bracket
(3) Screws for fixing the cable management bracket to the chassis
(4) Cable management bracket without a tray (installed at the upper part of the chassis)
(5) Cable management bracket with a tray (installed at the lower part of the chassis)
Attaching the cable management brackets on other models
For the models except the 7506-V, install the cable management bracket on the left mounting bracket, as
shown in Figure 1
management bracket screw holes is the left mounting bracket.
Figure 10.
1. The switch is supplied with two mounting brackets, and the one with the cable
2
4
3
1
2
5
3
1
14