Installing A Cfp Module - HP 7500 Series Installation Manual

For an SFP+ module, press the module down against the upward force of the bottom spring tab
so you can push the module straight into the port.
If you cannot hold the module by its two sides because of high module density, press the module
on its head end to push it in.
4. Connect the fiber to the module. For the installation procedure, see
network."
Figure 34 Installing an XFP/SFP+/SFP/QSFP+ module

Installing a CFP module

1. Wear an ESD wrist strap and make sure it makes good skin contact and is well grounded. For
more information, see
2. Unpack the CFP module. Do not touch the golden finger of the module.
3. Holding both sides of the module, gently push the module into the slot until it has firm contact with
the slot. See
4. Fasten the captive screws.
5. Connect the fiber to the module. For the installation procedure, see
network."
Figure 35 Installing a CFP module
(1) Gently push the module into the slot
"Attaching an ESD wrist
Figure 35.
2
1
strap."
2
(2) Fasten the captive screws
39
"Connecting your switch to the
"Connecting your switch to the