Peripheral Configuration - NEC Express5800/B120a User Manual

4-10 Configuring Your Server

Peripheral Configuration

IMPORTANT:
Note that the interrupt and/or base I/O address are not overlapped
with others. If the value set for the interrupt or base I/O address is
used in another resource, the yellow asterisk (*) appears. Reset any
item with the yellow asterisk properly.
If N8403-026 RAID controller is installed, "Serial ATA", "SATA
Controller Mode Option", "SATA AHCI", and "SATA RAID" are
not displayed.
Option
Serial Port B
Base I/O
address
Interrupt
Serial ATA
SATA Controller
Mode Option
SATA AHCI
SATA RAID
Parameter Description
Disabled Selects whether serial port B is enabled or
[Enabled] disabled.
3F8 Selects the base I/O address for serial port
[2F8] A.
3E8
2E8
[IRQ 3] Selects the interrupt for a serial port A.
IRQ 4
Disabled Selects whether the serial ATA is enabled or
[Enabled] disabled.
Compatible Selects an operation mode of onboard
[Enhanced] SATA controller. Displayed only when Serial
ATA is enabled.
Compatible mode:
SATA drives are automatically detected
and recognized as legacy mode.
Enhanced mode:
SATA drives are automatically detected
and recognized as native mode.
Disabled Selects whether AHCI (Advanced Host
[Enabled] Controller Interface) is enabled or disabled.
This item appears only when "SATA RAID"
is set to "Disabled".
Disabled Selects whether RAID feature of onboard
[Enabled] SATA controller is enabled or disabled.
Your Setting
[ ]: Factory-set