NEC Express5800/B120a User Manual page 55

Main
Option
System Time
System Date
Hard Disk Pre-Delay
Processor Settings
IMPORTANT:
operation if any of the following conditions is applicable.
After carriage of device
After storage of device
After the device is entered into the pause state under the
environmental condition enduring device operation (temperature:
10°C - 35°C, humidity: 20% - 80%)
Check the system clock at the rough rate of once per month. When the
system clock is installed in a system requiring high time precision, it is
recommended to use a time server (NTP server).
If the system clock is remarkably delayed or advanced as the passage of
time in spite of adjustment, contact your service representative for
maintenance.
Parameter
HH:MM:SS
MM/DD/YYYY
[Disabled]
3 seconds
6 seconds
9 seconds
12 seconds
15 seconds
21 seconds
30 seconds
Select submenu
Check and adjust the system clock before the
Configuring Your Server 4-5
Description
Set the system time.
Set the system date.
When accessing the internal
SATA hard disk drive for the first
time during POST, the system
waits for the specified time until
the drive becomes ready.
Shows the processor settings
submenu.
Your Setting
[ ]: Factory-set