Table of Contents
Advertisement
WV-CU850 System Controller
Replacing the Side Panels with the optional WV-Q62 Rack Mounting Brackets
1. Remove both the left and right side panels of the System Controller by removing four screws.
2. Remove the palm-rest located on the front of the System Controller by removing two screws.
3. Place the Rack Mounting Brackets on both sides of the System Controller and tighten with the four supplied screws.
4. Install the System Controller with Rack Mounting Brackets in the rack by using four screws (not included).
60
Palm-rest
Rack Mounting Screws
Side Panel
Remove screws.
Rack Mounting Bracket
Rack Mounting Screws
Tighten screws.
Advertisement
Table of Contents
